VTCR

Valmbeslag

VTCR er beregnet til samling af valmspær på alm. spær.

  • Kan indgå i konstruktive systemer
  • Montage fra en side
  • Justerbar fra 10° til 40° ved montage
  • Reducerer omkostningerne til valmspær-konstruktion
CE-merket
Avtalegrunnlag
Anvendelsesklasse 2
Varmgalvanisert stål 20 µm
Indoor

Produktinformasjon

Bilder

Egenskaper

Materiale

  • Stålkvalitet:
    Galvanisert stål S250GD + Z275 i henhold til EN 10346
  • Korrosjonsbeskyttelse:
    275 g/m2 på begge sider - i henhold til en sinklagstykkelse på ca. 20 μm

Tekniske data

Lastbæreevne tabell (karakteristiske verdier)

VTCR

Montering

Montering

Installation

  • Install VTCR with all specified fasteners:  3.35x65mm round wire nails into the supporting truss and 3.75x30mm square twsit nails into the valley truss
  • Position the VTCR onto the supporting truss and install the 3.35x65mm nail at an angle of 45º through the dome nail holes. (Fig 1)
    • Note:  when the supporting truss is 35mm thick, a portion of the nails will be exposed before penetrating into the side of the truss (Fig 3)
  • Bend the  uppper flange of the VTCR to the required angle; position the valley truss against this leg and install the 3.75x30mm nail into the bottom chord of the valley truss (Fig 1)
  • Install a VTCR on each of the top chords of the supporting trusses at each intersection of supporting truss and valley truss

Sertifiseringer

Ytelses Erklæring (DoP)

European Technical Assessment (ETA)

CAD og BIM bibliotek

3D

Buy from Distributor

No items available.

Contact

Simpson Strong-Tie Norge

Simpson Strong-Tie c/o Christiania Spigerverk

Org.nr: 9672 09 562
Smalvollveien 58
0667 Oslo
Norge